By Mike Stamm and Ignacio Ciampitti
The planting window for winter canola is around the corner. In this article, we outline the most critical management factors, ranging from seeding rates to insect and disease management, for a successful crop growing season. A companion article in this eUpdate addresses other planting aspects like variety selection and seedbed preparation.
Seeding Date
The general rule is to plant canola six weeks before the average date of the first killing frost (28 degrees F) in central and south central Kansas, or six to eight weeks for southwest and northern Kansas. This allows adequate time for plant canopy development and root growth to improve the chances for winter survival. Planting too late will result in small plants with inadequate reserves to maximize winter survival. Planting too early may result in excessive growth that can deplete soil moisture. Excessive growth may also elevate the growing point or crown too far above the soil surface, increasing the chance of winterkill. This can be a problem when heavy residue remains in the seed row without correct management.
In northern Kansas, winter canola should be planted by September 15 and in central Kansas by September 25. In far south central Kansas (Barber, Harper, and Sumner counties), winter canola should be planted by October 1 and in southwest Kansas by September 15 to avoid problems with winterkill. The most recent 3-month outlook from NOAA projects an increased chance of warmer-than-normal temperatures through November. The precipitation outlook is for below-normal precipitation across the state.
Seeding Rate, Depth, and Row Spacing
Winter canola will compensate for a poor plant stand; however, it is important to obtain as uniform a stand as possible to facilitate optimum plant development, winter survival, weed control, and uniform plant maturity.
A seeding rate of 3.5 to 5 pounds per acre (approximately 350,000 to 500,000 seeds per acre at a 100,000 seeds per lb seed size) is recommended for open-pollinated varieties in narrow row spacing. Because hybrids have higher seed costs of hybrids and greater ability to branch out, it is recommended to plant them on a pure live seed basis. The recommended seeding rate is 250,000 to 300,000 pure live seeds per acre in narrow rows.
More producers are experimenting with canola planted in 30-inch rows. Producers are able to obtain more accurate depth control, precision seed metering, and residue removal from the seed row with row crop planters. Generally, yields may be slightly reduced moving from 15 inches to 30 inches under dryland conditions. However, producers are able to reduce their seeding rate to 1.5 to 3.0 lb per acre (about 135,000 to 270,000 pure live seeds per acre at a 90,000 seed per lb seed weight). Planting an open-pollinated variety or hybrid with prolific branching will also increase the profitability of canola planted in 30-inch rows.
It is important to check drill calibration. Some drills may require a speed reduction kit to obtain the optimum rate without damaging seed. Some producers planting on 7.5-inch spacing will plug every other row unit and plant on 15-inch spacing, so the drill does not have to be slowed as much.
Seed placement is critical for successful germination, emergence, and stand establishment. Optimal germination occurs with seed placed ½ to 1 inch deep. Under drier conditions, canola may be planted deeper (not greater than 1.5 inches), but delayed emergence and reduced vigor may occur. Soil crusting following a heavy rain can result in a poor stand. Canola emergence can be greatly reduced when using a deep furrow opener followed by a heavy rain prior to emergence, since soil can fill in the furrow, resulting in a deeper than intended seeding depth. To ensure proper seeding depth, producers must plant slower than when planting wheat (preferably 5 mph or slower). Finally, it is important to check seeding depth in each field.
Rows spaced between 7.5 and 15 inches allow for rapid canopy closure (improved light interception) and weed control. Yields are similar with row spacings in this range. Plant-to-plant uniformity at emergence is critical for optimum plant development, overwintering, and weed control.
Plant Nutrition and Soil Fertility
Soil testing, including a profile sample for nitrogen (N) and sulfur (S), is an important tool in determining fertilizer needs. If you have questions, contact your local Extension office. Canola fertility recommendation programs, based on soil test levels, can be found at: http://www.agronomy.ksu.edu/soiltesting/
Fertility needs are similar to winter wheat; however, canola needs slightly higher N and S. Applying high rates of fertilizer in-row at planting is not recommended because canola is sensitive to ammonia and salt damage (phytotoxic effects). However, research by Oklahoma State indicates that a low rate of DAP or MAP (30 to 40 lb/acre of product) is beneficial and not detrimental to yield. The best management practice for banding fertilizer should separate the fertilizer from the seed by two inches to avoid direct contact. Pre-plant broadcast application is also acceptable.
- Lime: Apply lime so that pH is in the range of 5.5-7.0 and early enough so the lime has time to react.
- Phosphorus (P) and Potassium (K): No added P is required if the P soil test is above 30 ppm. Additional K should be applied if soil test levels are less than 125 ppm.
- Sulfur: Canola requires S because of its high content of sulfur-containing proteins. Sulfur deficiencies are most common on coarse-textured and low-organic-matter soils. Sulfur can be applied at any time from pre-plant until the canola plant breaks dormancy in late winter. Apply S based on the soil test recommendation. Sulfate-sulfur (SO4-S) soil tests should be above 10 ppm or fertilizer should be applied. If no soil test is available, an application of 20 lb/acre S is recommended.
- Nitrogen: Pre-plant N applications must be carefully balanced, as too little or too much fall-applied N may negatively affect winter survival. One-third to one-half of total N (based on expected yield) should be fall-applied. At least 30 lb/acre but no more than 80 lb/acre of actual N is the general rule for fall applications. Winter survival, plant vigor, and yield potential can decrease without applying fall N.
Weed Management
A clean seedbed is critical to establishing winter canola. Small canola seedlings compete poorly with established weeds. However, once a good stand and canopy are established, canola suppresses and outcompetes most winter annual weeds. No matter what herbicide program you use, the most important thing to remember is to control weeds early in the fall.
- Trifluralin and ethalfluralin are effective at controlling winter annual weeds pre-plant, but each requires mechanical incorporation.
- Grass herbicides such as clethodim, quizalofop, and sethoxydim are labeled for cool-season grass control in canola.
- Roundup Ready (glyphosate tolerant) canola varieties are available, providing excellent control of many problem weeds. Glyphosate is not labeled for application once the plant has bolted after dormancy.
- Clearfield canola varieties are available and provide another herbicide resistance option for controlling winter annual grasses.
- Before applying any herbicides, care must be taken to ensure there are no traces of problem herbicides, such as sulfonylurea herbicides, in the sprayer equipment.
Insect Management
An insecticide seed treatment is highly recommended for control of green peach aphids and turnip aphids through fall and early winter. Monitor canola stands for the following fall insect pests: grasshoppers, diamondback moth larvae, flea beetles, aphids, and root maggots. Several products are labeled and provide good to excellent control.
Disease Management
The best control of canola diseases is achieved through careful rotation. Canola should not be planted on the same field more than once every three years and should never be planted continuously.
Blackleg (Leptosphaeria maculans) is the most serious disease threat to canola. Maintaining proper rotation intervals, planting disease-free seed, and using fungicide seed treatments are important management practices to slow the spread of blackleg. Damping-off of young seedlings, which resembles the pinching of the stem at or just below the soil line, is caused by several fungi including Pythium, Fusarium, and Rhizoctonia. A fungicide seed treatment can lessen the effects of these soil-borne diseases.
Source : ksu.edu